Clean Build Platform

Device
Einstein™
Einstein Pro XL™

NOTICE

Use 99% IPA away from the material tray and thoroughly wipe all IPA completely from the build platform before installing it back onto the printer.

Time needed: Approximately two minutes

Maintenance frequency: Print-by-Print

The build platform should remain as clean as possible between print jobs to keep your printer in optimal printing condition. The build platform should be cleaned when:

  • build platform becomes sticky
  • material cures around the build platform clamping handle
  • when changing the material type
  1. Clean the connection cavity at the top of the build platform using a Q-tip with 99% IPA.
  2. If too much material has cured in the torque knob screw threading, replace the build platform.
  3. Clean the surface of the build platform with a clean paper towel.
  4. Check every surface for material, buildup, or stickiness. 
  5. Clean the excessive buildup using a small amount of 99% IPA on a clean paper towel or Q-tip.
  6. Hard spots of cured material can be carefully scraped off using the paint scraper from the Starter Kit.