Manual Debris Removal

This tab helps simplify the process of cleaning the material tray.

To remove debris from the material tray, complete the following steps:  

  1. Select Settings > Manual Debris Removal to open the tab.

  2. Set the required exposure time using the + and – icons.

  3. Select Expose.

    → The entire material tray area is exposed.

  4. Remove debris from the material tray by lifting the thin film of the exposed material.

  5. Proceed following the step-by-step for filtering material described on the Maintain Materials page, if needed.

Note: The material tray is consumable with an approximate lifespan of up to 150 prints. Order a new material tray before the current tray expires or becomes damaged. The expired material tray can be disposed of.
Important: Material tray deterioration may be noticeable around 100 to 150 prints, depending on the application.