Once the job is complete, the printed models hang off the build platform.
To remove the models, proceed as follows:
1. Place the build platform on its side in the processing zone as shown in the diagram below. Watch the material so it doesn’t leak into the build platform cavity. Ensure the magnet stays clean.
2. Hold the build platform handle with one hand to steady the platform.
3. Use the scraper from the Starter Kit to gently detach models from the build platform. Angle your tool roughly 30 degrees from the platform and move the blade while applying a slight amount of pressure.
4. Place each model on a paper towel to catch the excess material as it drips.
Notice: If the model doesn’t begin to separate easily, move to a different area on the model, working your way around the model until it safely dislodges from the build platform.
Tip: Note that the models appear to be glossy. This is because uncured material is covering the surface.