This article shows the issues listed in the Request Support feature and the ways to address them.
Job will not start.
- Resend the job to printer, see Send Job to Printer.
- Try starting the job.
Printed model(s) fell off the build platform into the material tray.
See Troubleshooting Cases Einstein for details.
Excess cured material in the material tray.
- Clean your material tray using the Manual Debris Removal feature, see Manual Debris Removal Einstein.
- Clean the safety glass, see Clean Safety Glass Einstein.
- Check Projector Power - contact Customer Support for assistance.
Excess cured material on the printed model.
- Clean your material tray using the Manual Debris Removal feature, see Manual Debris Removal Einstein.
- Clean the safety glass, see Clean Safety Glass Einstein.
- Check Projector Power - contact Customer Support for assistance.
Material is incorrect color.
Be sure to properly prepare your specific material before each use. Always observe the relevant Material Safety Data Sheets supplied with the material bottle. Maintain the materials correctly, see Maintain Materials Einstein for details.
Printer will not turn on or off.
Restart your printer completely, see Power Cycle Einstein for details.
Job cannot transfer to the printer.
1. Make sure to transfer your print job properly, see Send Job to Printer for details.
2. Check that your printer is connected to the network. See Connect Ethernet Einstein and Set Up Wi-Fi Einstein.
Poor surface quality of the printed model(s).
See Troubleshooting Cases Einstein for details.
Printed model is missing layers or features.
See Troubleshooting Cases Einstein for details.
Partially successful print.
See the Partially Successful Print section to help you identify, isolate, and resolve printer issues.
No network connection.
Build platform will not move up or down.
1. Restart the printer, see Power Cycle Einstein.
2. Update the printer, see Update Einstein.
3. If the previous steps did not work, contact Customer Support.
Envision One RP Software job cannot be created.
Job generation fails: This error message appears when trying to upload jobs via FTP to the offline printer. To fix it, check the internet or network connection on the printer.
Job can't be saved: When the error message appears telling that the job cannot be saved to the restricted directory, it means that there are no permission rights to write to the chosen directory. Select another directory for saving a job.
Job can't be sent: When the error message appears telling that the job cannot be sent to the printer, it means that the printer settings or buildstyle settings should be changed. The technicians and support specialists could perform these actions. Please contact Customer Support.
Envision One RP Software crash.
Try updating your Envision One RP, see Install Envision One RP.
Cured or uncured material under the material tray.
1. Clean your material tray, see Clean Material Tray Einstein.
The material tray is consumable with an approximate lifespan of up to 150 prints. Order a new material tray before the current tray expires or becomes damaged.
2. Clean the printer safety glass, see Clean Safety Glass Einstein.
Print accuracy is not satisfactory.
Calibrate your printer, see Printer Calibration in Envision One RP.
Material tray is damaged.
The material tray is consumable with an approximate lifespan of up to 150 prints. Order a new material tray before the current tray expires or becomes damaged, see Clean Material Tray Einstein.
An incorrect home position can exert excess pressure on the material tray. See Automatic Home Position Calibration Einstein and Manual Home Position Calibration Einstein.
Job completed with no cured material on the build platform or in the material tray.
This may be caused by the issue with Projector’s LED, see Power Cycle Einstein.